Thingiverse
Wargaming Movement Trays
von kitch72
18
Downloads
6
Likes
0
Makes
Movement trays for wargaming.
They hold a standard 25mm Round Base. I was aiming for minimal, I had done them thinner to save plastic, but they were warping, and flexed with metal minis on, so this is a thicker stronger version.
I initially did a 10 man base (5x2) for Oathmark, then also did a 5 man tray too.
I also added an 8 man tray for Infamy, Infamy, but could also work for Sharp practice.
Print them on lowish detail, the 5 Man tray prints in about 40min, then 10 man in about an hour and a half.
Support free (unsuprisingly!)
They hold a standard 25mm Round Base. I was aiming for minimal, I had done them thinner to save plastic, but they were warping, and flexed with metal minis on, so this is a thicker stronger version.
I initially did a 10 man base (5x2) for Oathmark, then also did a 5 man tray too.
I also added an 8 man tray for Infamy, Infamy, but could also work for Sharp practice.
Print them on lowish detail, the 5 Man tray prints in about 40min, then 10 man in about an hour and a half.
Support free (unsuprisingly!)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!