Thingiverse
Warhammer Auspex Scanner
von asciencepotato
263
Downloads
205
Likes
1
Makes
Check out my youtube channel for 3D printing and 3D design videos! https://www.youtube.com/channel/UCuHuFfEPBPNv9AmoDYmXFiQ
Not sure where them heretics are? Need to do some purging but those tricky genestealers won't tell you were they are? Well you need an Auspex Scanner!
This prints as 1 single piece! so all you have to do is print it, and paint it! (if you want to)
***it is important to note that to get the best quality you will want to tilt the part 30 degrees back on the buildplate and then add a small support block on the base to hold it in place while it prints (just like in the photo). this prevents any support material from actually touching the features on the print, meaning it will look the best it can!
Check out my collection of Warhammer props!
Warhammer Omnisian Axe - https://www.thingiverse.com/thing:3213857
Warhammer Triple Laspistol - https://www.thingiverse.com/thing:3347377
Warhammer Laspistol - https://www.thingiverse.com/thing:3499538
Warhammer
Not sure where them heretics are? Need to do some purging but those tricky genestealers won't tell you were they are? Well you need an Auspex Scanner!
This prints as 1 single piece! so all you have to do is print it, and paint it! (if you want to)
***it is important to note that to get the best quality you will want to tilt the part 30 degrees back on the buildplate and then add a small support block on the base to hold it in place while it prints (just like in the photo). this prevents any support material from actually touching the features on the print, meaning it will look the best it can!
Check out my collection of Warhammer props!
Warhammer Omnisian Axe - https://www.thingiverse.com/thing:3213857
Warhammer Triple Laspistol - https://www.thingiverse.com/thing:3347377
Warhammer Laspistol - https://www.thingiverse.com/thing:3499538
Warhammer
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
