Warmachine/Hordes Objective Marker

This is a Warmachine/Hordes objective marker for use in steamroller scenarios that use objectives.

This is provided with two options to print:
1. The whole model: Objective3 - Whole.stl. Be prepared to have good support and overhang ability. I think of this mostly for show, but it's probably possible to print from it.
2. A set of pieces that can be printed mostly flat - there's a bit of overhang on the inner and outer polar rings, where the slot is angled to fit, but that's it.

It's best printed in pieces and assembled from the inside-out:
1. Slot the disc in the inner polar ring at a 30 degree angle (follow the notches). Don't glue until you've slotted it into the outer polar ring and made sure that you know which side is up.
2. Slot the inner polar ring with disc into the outer polar ring so that it is at a 30 degree angle from the disc and 60 degrees from the inner polar ring (follow the notches).
3. Slot the outer polar ring, inner polar ring, and disc into the equato