Thingiverse
Warmaster Bases (magnet ready)
von martijn7234
78
Downloads
27
Likes
0
Makes
Some bases for Warmaster (Revolution)!
A 40x20mm base for the troops and a Ø20mm for the characters.
You can fit up to three Ø3x1mm magnets on the rectangle and one on the round base.
I print them upside down on the print bed with a brim that I cut off afterwards.
The models are not mine, they are made by forestdragon3d, who runs a wonderful patreon.
EDIT 2021-03-26: Depending on shrinkage, the hole could be too small for the magnet. I added a "loose" version to compensate for this. Old version renamed to "tight"
EDIT 2022-01-17: Added "General" round base Ø25mm and "Trebuchet/Stegadon" base 60x40mm
A 40x20mm base for the troops and a Ø20mm for the characters.
You can fit up to three Ø3x1mm magnets on the rectangle and one on the round base.
I print them upside down on the print bed with a brim that I cut off afterwards.
The models are not mine, they are made by forestdragon3d, who runs a wonderful patreon.
EDIT 2021-03-26: Depending on shrinkage, the hole could be too small for the magnet. I added a "loose" version to compensate for this. Old version renamed to "tight"
EDIT 2022-01-17: Added "General" round base Ø25mm and "Trebuchet/Stegadon" base 60x40mm
martijn7234 veröffentlicht auch auf
6 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
