wasp 76 nerf

Adapted to wasp 76, grip movement

One M4X50 screw and one nut to replace the pin in the middle of the gearbox

There are 8 m3x8 screws, preferably flat head or countersunk head screws, to fix the two wrench units, and the front and rear grip groups are respectively 4 screw holes



The grip is fixed with its own screws. The original grip position is fixed with the same set of screws


The trigger needs to be disassembled and installed. The installation method is the same as that of the original trigger. Pay attention to the installation of the trigger spring to a new position.



需要一根
M4x50螺丝1个和螺母1个，替换机匣中间部位销钉
M3x8螺丝8个，最好是平头或者沉头螺丝，固定两个扳机组，固定前后握把组分别为4个螺丝孔

握把固定使用自带螺丝，原来握把位置同理使用那一套规格螺丝固定

扳机需要拆壳安装，安装方式和原来扳机一摸一样，注意扳机弹簧安装到新的位置。