Wasp Trap - improved performance & fast printing

Since in germany wasps get very annoying, I decided to test some wasp traps here. I tested a view but was finally not very lucky about them. So i decided to do my own based on best practice.

This is a remixed version of https://www.thingiverse.com/thing:1000336

Improvements have been:
- fast printing time
- big wasp bag
- proofed concept for wasps to enter, however, from the old design, the wasps have been able to frequently leave the trap again. So I changed the channels for the wasps to enter to make it more likly for the wasp to be trapped.

The trap is easy to use and clean.

I tested my trap with Glass filament, but due to this it was not very sealed and I encountered a leak. Please report if you use usual PLA / ABS of the material wall thickness is sufficient to be sealed.

You should take some beer and sugar to put it into the trap from the above opening.
Once the wasps are dead, you can easy clean it by flooding it with water.

I also included some pictures fr