Waster schilt V2

Improved Schilt for snow pole waster.

After the first training session one of the V1 wasters broke at the point where the crossbar rod went through. The hole for the crossbar rod and the hole to fixate the rod with a screw made that point too weak for light to average drills.

improvements:

*holes to fixate two separate crossbar rods on either side of the snow pole. No need to bore an 8 mm hole.

*holes to fixate the schilt on the snow pole with short screws.

*center hole for the snow pole is a bit bigger so the bending of the pole don't cause stress on the layers and risk them to crack.