Watch Display stand

This is a watch display stand designed by me in order to display my 3 watches.
It can display up to 3 watches
The prints are overall very easy and do not require any supports nor rafts, etc.
There is a total of 5 parts, but only 3 prints.
eg print: stand v1, rod v2 smaller edition, 3x watch cushions v2.

NOTE:
- The rod that runs through the watch cushions is slightly loose and will cause the cushions to rotate when a watch is attached due to the weight. To fix this issue, Wrap 1 layer of tape (can be any, I used black duck tape) underneath where the cushion would sit. This makes it tighter and a better fit.
- The rod has a little triangle tab on one end. This is the end that goes into the hole with the triangle cutout. Also when attaching the cushions, make sure to align the triangle tab with the cutout in the cushions. When the rod is attached to the stand, the triangle tab should be inside the cutout (Not outside) to stop the rod from rotating.