Slicer Discord
water generator – 3D-Druckmodell von GrabCAD GrabCAD
STEP / IGES

water generator

von Roy · STEP / IGES
84 Downloads
12 Likes
0 Makes
Zum Modell
this water generator works by two fans which are powered by solar panels, the fans suck air through the tubes. the pipes running under the ground, at the lowest point is a water collection tray. because the pipes under the ground running, the temperature is cooler there, the ground heats up during the day by the warm air that goes through the tubes. daytime sure the solar panels that the fans are working and charging the battery. snachs the battery is used to cool air through the ground to suck. at 70% humidity and 25 degrees Celsius, there is 15 grams of moisture per cubic meter of air. So there must be about 70 cubic meters of air flowing through the tubes, to one liter of water per hour to make. This system will especially at the beginning of the day to be effective. the water is pumped up when the tank is at a certain level, by the pump is pumped in three 2 liter bottles. if it is full then it is pumped into an underground shelter. the reception is pumped back into the bottles as they are geleegt. The whole system is controlled by a Siemens logo. I used google translator to make this description so it may be that some strange things in it btw grabcad tanks for some models I used
Kategorie
STEP / IGES
Quelle
GrabCAD
Veröffentlicht
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STEP, STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen