Slicer Discord
Water Pipe w/ Tri Pull Matrix – 3D-printbaar model van Thingiverse Thingiverse

Water Pipe w/ Tri Pull Matrix

door Codasm
88 Downloads
51 Likes
0 Makes
Model downloaden
Stylish Water Pipe with Tri Pull Matrix produces a smoother hit.

Requires a 14mm bowl

3D PRINTING SETTINGS
I used .25 layer height for all parts but of course you can print @ a higher resolution if you wish

Retraction settings:

Only retract when crossing open spaces
Minimum Travel for retraction 6mm
Perform retraction during wipe
I did not use 'Avoid crossing outline for travel movements' as this for some reason doesn't print as well especially along the start line/seam.

Select 'Choose start point closest to specific location' and rotate parts in your slicer until seam is down the back of the part(s)

I used supports only for the Connector.stl as there is an inside rim, you may have good results without supports with your printer, it's a small piece so I would try without supports first.

I find the bowl will leak eventually if it is not coated on the inside

To coat the bowl:

Varathane Diamond Wood Finish - Interior Water based poly - I think I paid $9.00 C
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Waarom?
geen supports
Zonder supports Eendelig
Supports 0/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Wood PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie