Slicer Discord
Water Pump Mount – 3D-Druckmodell von Thingiverse Thingiverse

Water Pump Mount

von olendorf
18 Downloads
19 Likes
0 Makes
Zum Modell
This is a counter top mount to allow a water jug pump to be counter-mounted instead of placing it on top of the water jug. This works great for camper vans that want the battery powered water pump, but want it attached to the countertop.

This is designed for the pump in the picture but it should fit most pumps that will attach to a water bottle.

There is a groove running around the mount about 1/3 of the way from the top. This was so that if the fit was too loose you are able to put an o-ring in there to snug it up. It's already pretty snug with my faucet pump so I don't need an o-ring.

Drill the hole in the countertop for the water line. Screw or glue the mount to the counter. Press fit the faucet onto the mount.

6/3/23 Added a 2" taller mount.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Mindest-Druckbett
50 mm (Klein)
Nachbearbeitung
Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

olendorf veröffentlicht auch auf

23 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

1 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen