WaterClaws V3

This is my entry for the Master Challenge: Water Spray Contest! I wanted to create a fun and unique prop for this summer’s garden water battles — and so I present to you: The Water Claws!They take a bit of technique to master, but once you get the hang of them, you’ll feel the sheer power of the claws in action. Think less spinning and more of an uppercut-style motion — like throwing a lacrosse ball, but instead you're launching water! There’s something unforgettable about wielding your very own (adamantium?) water-spraying claws. It’s part superhero, part garden warrior — and 100% fun. Each claw prints in one piece. Depending on your print settings, a single claw takes around 4 to 4.5 hours. So for a full set of two claws, expect about 8 to 9 hours of print time. Build & Safety Notes:The model is designed with smooth contours and minimal sharp edges to make it as kid-friendly as possible. For extra durability — especially for smaller, enthusiastic users — I recommend printing with