Thingiverse
Watering Can
von les_kaye
39
Downloads
25
Likes
0
Makes
Watering Can and Rose
===========
For watering house-plants.
The larger can is as big as will fit on my print table (225x155x170mm) and has a capacity of 1.7L (3 pints). The smaller can will contain 900ml (1.5 pints).
Use PLA for good layer and paint adhesion. After printing, it is best to spray-paint your can as it may leak slightly between the print layers.
===========
For watering house-plants.
The larger can is as big as will fit on my print table (225x155x170mm) and has a capacity of 1.7L (3 pints). The smaller can will contain 900ml (1.5 pints).
Use PLA for good layer and paint adhesion. After printing, it is best to spray-paint your can as it may leak slightly between the print layers.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!