Thingiverse
watering can
par steinboy
1k
Téléchargements
785
Likes
9
Makes
Ergonomic watering can
-IMPORTANT: Print in SPIRAL (VASE) mode with 0.8mm nozzle and 0.2-0.4mm layer height.
smaller nozzle sizes can be used but extrusion width should be 0.8 for adequate strength.
-bottom layer should be at least 4 layers of rectilinear fill pattern and make sure printer is not under-extruding to ensure water tightness. (if there are some leaks around the bottom edge seam you can fix it with some CA (super glue) along the seam on the inside.)
-Full volume is approximately 1.7 litres, useable volume 1.4-1.5 litres.
-IMPORTANT: Print in SPIRAL (VASE) mode with 0.8mm nozzle and 0.2-0.4mm layer height.
smaller nozzle sizes can be used but extrusion width should be 0.8 for adequate strength.
-bottom layer should be at least 4 layers of rectilinear fill pattern and make sure printer is not under-extruding to ensure water tightness. (if there are some leaks around the bottom edge seam you can fix it with some CA (super glue) along the seam on the inside.)
-Full volume is approximately 1.7 litres, useable volume 1.4-1.5 litres.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
