Thingiverse
Waterproof Apocalypse Box
por GSMArtFPV
144
Descargas
108
Likes
0
Makes
Watertight. 65mm diameter. you will need to be TPU enabled for this one.
I suggest printing the lid in a bright colour so you can find it if it gets dropped.
if you feel the need to scale this down don't go less than 80% otherwise the lid will be tight (i havent tested this btw, it's a hunch)
Print with support, there is a teeny gap for the TPU gasket to squeeze into, just underneath the main box thread. this would sag horribly without support. dont worry, it's only needed for a portion of the circumference and it's only 1mm thick.
Uploaded files are in 3mf. it's a mesh same as STL. cura and S3D can handle it so's you wouldn't even notice the difference. Why do i use it? my PC will make a thumbnail of 3mf unlike STL which remain mysterious after months have gone by.
If you really neeed STL then ask nicely and i will oblige
I suggest printing the lid in a bright colour so you can find it if it gets dropped.
if you feel the need to scale this down don't go less than 80% otherwise the lid will be tight (i havent tested this btw, it's a hunch)
Print with support, there is a teeny gap for the TPU gasket to squeeze into, just underneath the main box thread. this would sag horribly without support. dont worry, it's only needed for a portion of the circumference and it's only 1mm thick.
Uploaded files are in 3mf. it's a mesh same as STL. cura and S3D can handle it so's you wouldn't even notice the difference. Why do i use it? my PC will make a thumbnail of 3mf unlike STL which remain mysterious after months have gone by.
If you really neeed STL then ask nicely and i will oblige
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
