Slicer Discord
Watertight Containers – 3D-printbaar model van MakerWorld MakerWorld
Organizers

Watertight Containers

door AuxArc · Organizers
65 Downloads
35 Likes
27 Makes
Model downloaden
Originally designed by myself as a water tight battery storage solution outdoors, I repurposed it as a generic water tight container. I have four sizes here, with approximate measurements. The 25mm id version with a 50mm height and 100mm height, and then the 40mm id version with the same selection of heights. The lid drops on and does a quarter turn to latch and an o-ring can be purchased from your local hardware store to get the watertight effect. The container is good in rain, humidity, fog and other outdoor wet environments, probably even boating, but only if not you're not expecting constant or frequent submersion. As far as ratings go, this would land about IP64.O-ring needed for the 25mm version has the following specs:ID 1-5/8"OD 1-¾"Width of 1/16". Could bump up to 3/32nd but it can be pretty difficult to open and close at that point without some lubrication.Industry #30 is the 1/16". O-ring needed for the 40mm version has needs to be at least 2 1/16", b
Categorie
Organizers
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Min. bedgrootte
50 mm (Klein)
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

AuxArc publiceert ook op

6 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

1 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie