Watt Governor 瓦特离心调速器

Watt Governor Model for Demonstrating Centrifugal Force and Gear-Rod TransmissionThe original device was used to regulate steam input and is a milestone in mechanical automatic control;In the model, steam input control is replaced with a “dial” to visually show the size of the centrifugal force.Assembled dimensions are approximately 260*90*180mm.瓦特速度调节器模型 用于展示离心力和齿轮、连杆传动原装置为调节蒸汽进入量，是机械自动控制的里程碑；模型将蒸汽进入控制，改为了“表盘”，以直观展示离心力的大小组装后尺寸约 260*90*180mm Simulates a double-ball centrifugal governor to demonstrate centrifugal force. Input via high-ratio gear transmission Linkage pushes the “centrifugal force gauge” for a visual display The two balls in the print are filled at 75% to increase weight Bushing design: Shaft printed horizontally, bushing printed vertically to ensure strength and improve smoothness, no extra lubrication needed Bushings and sliders use random seams  Chassis, bushings, and support seats use PLA.  Others use PETG.  A few supports and the pointer might need glue, and the main shaft might need some sanding.模拟双球离心调速器，演示离心力齿轮大比例传动输入连杆推动“离心力表”直观展示打印配置中双球使用75%填充增加重量轴套设计，轴横向打印，轴套纵向打印，保证强度同时提升光滑度，无需额外润滑轴套、滑块使用随机接缝Non-3D-printed parts required:1. M2.5*10 screws, 10 pcs 2. M5*8 screws, 2 pcs (optional, used for weights) 3. 608 bearings, 3 pcs 4. 6806 bearing, 1 pcs 非3D打印件需要1、M2.5*10 螺丝 10个2、M5*8 螺丝 2个（可选，非必须配重使用）3、608轴承3个4、6806轴承1个 Assembly instructions:For the final step of adjusting the pointer’s direction, please adjust based on the tooth engagement of the back gear during installation.组装示意：最后一步指针的方向，请在安装时通过背面齿轮的咬合位置调整。