Thingiverse
Watt Meter With Binding Post
door Antairus
3
Downloads
4
Likes
0
Makes
My First Design! Yay!
Parts Req:
#10-32x1 in Nuts and Screws.
You have to Drill out the top of the post with a 11/64 Drill Bit.
It will fit right in the hole for the top of the binding post, and when it punches trough
the bottom will just fall out. This is so the screw head sits inside.
I used rounded screws because that's all I had. I had to flatten the head with a Dremel to make it flush.
Parts Req:
#10-32x1 in Nuts and Screws.
You have to Drill out the top of the post with a 11/64 Drill Bit.
It will fit right in the hole for the top of the binding post, and when it punches trough
the bottom will just fall out. This is so the screw head sits inside.
I used rounded screws because that's all I had. I had to flatten the head with a Dremel to make it flush.
Antairus publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!