Slicer Discord
Wave Pen Carousel and Caddy – 3D-printbaar model van MakerWorld MakerWorld
Office

Wave Pen Carousel and Caddy

door LoboCNC · Office
77 Downloads
45 Likes
45 Makes
Model downloaden
If you are one of us who spends more time playing with your desk accessories than you spend actually working, this pen carousel is for you! As you rotate the carousel, your favorite pen will present itself for the taking. It also has a little stack of trays in the center for all your desk doodads like rubber bands, paper clips, etc.. Prints and assembles easily with no supports or added hardware. You can use any length pen with this, but to get the best wave-effect, the end of the pen should sit flush with the top of carousel. Each pen actually sits on a little booster block that gets pushed upward by the wave generator in the base. I've provided three different height booster blocks: the shortest for longer pens, the tallest for shorter pens and the mid-sized for medium length pens. Just slide the best-fitting booster into each tube before inserting your pen. Then, the whole carousel slides over the post on the base. Lastly, you can optionally add some non-skid feet to the bottom of t
Categorie
Office
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Waarom?
geen supports
Zonder supports Eendelig Hardware nodig
Supports 0/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

LoboCNC publiceert ook op

313 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie