Thingiverse
wavebird controller stand
door Muppet2119
2
Downloads
6
Likes
1
Makes
wavebird comntroller stand.
this is taken from a scan of the back of a wavebird so is a little snug.
would recomend 0.12 or smaller layer hight.
and if you have adaptive layer hight set it to as smooth as possible ( this just makes the inside look nicer)
will rest in the stand and lift out easily. you can also press it down with a little force and it will fully sit down, but you will need both hands and a little tug to remove. i imagine it will get easier to remove with time.
this is taken from a scan of the back of a wavebird so is a little snug.
would recomend 0.12 or smaller layer hight.
and if you have adaptive layer hight set it to as smooth as possible ( this just makes the inside look nicer)
will rest in the stand and lift out easily. you can also press it down with a little force and it will fully sit down, but you will need both hands and a little tug to remove. i imagine it will get easier to remove with time.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!