Thingiverse
WD40 straw
di Mahoganut
86
Download
49
Likes
0
Makes
This printed quite well on my Flashforge Finder but it did need a little sanding to fit my WD40 can. I think this is due to the entry/exit points during the print, as the straw is so small it appears slightly misshapen. I had it in my can after about 20 seconds of sanding.
I had no need for a long straw but you can make it longer in your slicer if you require.
Speed: 50mm/s
Infill: 100%
Layer Height: 0.08mm
I had no need for a long straw but you can make it longer in your slicer if you require.
Speed: 50mm/s
Infill: 100%
Layer Height: 0.08mm
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
