WE SCAR front rail

I wanted a longer rail on my WE SCAR-L GBBR, and all the ones I found were either for the VFC SCAR or so out of spec that one has to wonder if the designer actually tested the model on a WE SCAR.

You'll need the following hardware:
2x M5x16 or M5x18 countersunk screws
M5 tap to tap the holes in the side of the lower mount point
2x M4 hex or square nuts for the top mount point

All other screws are reused from the old side rails.

The side rails are a little snug, so you may have to gently hammer them on to the main body, depending on your printer.

I've added some pictures showing the print orientation I used.