Wearable Apple Watch Prop

With the new Apple Watches around the corner, I needed a placeholder for a gift so I made this. It's a quickie, but it comes together nicely with superglue and a little spray paint. It takes about 2.5hrs to print everything. Add another 45m to finish, paint, and assemble.


Band
-------
I used ninjaflex for the band, but anything suitably flexible should work. Make sure it prints slowly, without retractions, and small layers (ie 1500mm/min, 0.2mm layers). Increase your top and bottom solid layers to match the 9 total layers in the band print. Precutting the filament and leaving it above the printer helped me get a nice smooth feed.

Watch Body
----------------
The parts are all separate to allow for easy painting. I used PLA with 0.1mm layer height and batch printed them which gives the clasp time to cool. No supports.

Assembly
-------------
1. After any painting and finishing, superglue the button and crown to the side.
2. Put the 3 holes on each end of the band throug