Thingiverse
Weather Station
di samsquancher
38
Download
30
Likes
0
Makes
This is a DIY weather station I design for a college project. All STL files I printed on an ultimaker 2 with default settings. These are all V1 models. The measurements for the attachments between the support arms and the rain gauge housing (case_with_attachement.stl) and the main housing (weather_station.stl), are slightly wrong so I had to sand down parts of the print to make them fit. I'll reupload corrected models as soon as I get a chance.
The anemometer assembly is measured to take an M8 threaded bar and 2 bearings.
The support_arms.ai are designed to be laser cut. The design is for any material that is 5mm thick, and can be slotted together to make rigid structures. I used a sheet of Acrylic, 1000x500x5mm, and the arms came out nice and strong. They're should slide over any 20mm diameter pole, however I haven't yet taken into account that they can rotate freely about the pole and will need to be fixed in place.
The anemometer assembly is measured to take an M8 threaded bar and 2 bearings.
The support_arms.ai are designed to be laser cut. The design is for any material that is 5mm thick, and can be slotted together to make rigid structures. I used a sheet of Acrylic, 1000x500x5mm, and the arms came out nice and strong. They're should slide over any 20mm diameter pole, however I haven't yet taken into account that they can rotate freely about the pole and will need to be fixed in place.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!