Weather Vane

This is a traditional type weather vane to attach to a facia board. You will need two bearings from Amazon 15mmx27mmx7mm

I printed the whole thing on a neptune 3 max and an ender 3.

The ship can be replaced by anything you fancy so long as it is 3.9mm in width to fit the slot on the bar.

Place the bracket on your facia make sure it is vertical, use the extension if you need to increase the height, slide the collar over the pillar and orientate it so North points north and use a bit of superglue to fix it into place.

Put one bearing inside the pivot then the spacer then the second bearing (glue this one in place and slip it over the spindle on top of the pole.

Could not find one on here so put this one up for anyone who wants to make it.