Thingiverse
Weather Vane
door cfresh
2
Downloads
10
Likes
0
Makes
Weather Vane to mount on a post or horizontal surface.
To maintain a good balance I used 2x bearings (608ZZ ID 8mm OD 22mm H 7mm) with a spacer in the middle and then locked into place with spacer. You can use 3x bearings if you wish as the spacers are the same height as a bearing, but I wanted less resistance.
The stand offs on the base were intended for a locking collar so the vane would not come detached but the fit is good enough for me. I may end up using them for N E S W letters later on.
Clamp V2 adds water protection to the bearings by adding 2mm top to the bearing cage.
Added N E S W
Added stl files
Made a new arrow in 2 parts for easier printing
Added a 2nd chook
To maintain a good balance I used 2x bearings (608ZZ ID 8mm OD 22mm H 7mm) with a spacer in the middle and then locked into place with spacer. You can use 3x bearings if you wish as the spacers are the same height as a bearing, but I wanted less resistance.
The stand offs on the base were intended for a locking collar so the vane would not come detached but the fit is good enough for me. I may end up using them for N E S W letters later on.
Clamp V2 adds water protection to the bearings by adding 2mm top to the bearing cage.
Added N E S W
Added stl files
Made a new arrow in 2 parts for easier printing
Added a 2nd chook
cfresh publiceert ook op
31 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!