Thingiverse
Weatherproof Outlet Box
door kronoscr
1
Downloads
2
Likes
0
Makes
Well, I decided to make a weatherproof outlet box based on some characteristics of On Market products and my own testing/failures. This design was made for 120V straight-Blade Receptacles.
The hinges of the lid have a diameter hole of 2mm, so a core pin could be used or a cheaper way is to use a nail, which I did.
I added two snap fit features, so it lock strong and requires a bit of force to open.
For installation, it could be placed in vertical or horizontal places.
I made an internal wall around the outlet cavity, so that if water leaks through the openings, it will move along the sides and not enter the receptacle. I also left a small hole in the snap cavities, so the water can drain through them.
The hinges of the lid have a diameter hole of 2mm, so a core pin could be used or a cheaper way is to use a nail, which I did.
I added two snap fit features, so it lock strong and requires a bit of force to open.
For installation, it could be placed in vertical or horizontal places.
I made an internal wall around the outlet cavity, so that if water leaks through the openings, it will move along the sides and not enter the receptacle. I also left a small hole in the snap cavities, so the water can drain through them.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
