Slicer Discord
WeBoost Antenna Mount – 3D-Druckmodell von Thingiverse Thingiverse

WeBoost Antenna Mount

von divernick
18 Downloads
5 Likes
0 Makes
Zum Modell
In my RV, I wanted to mount the internal antenna for the WeBoost Drive 4G-X RV (470410) from the ceiling for a couple reasons...one it provided me the best position to present the signal throughout the 5th wheel and it held it permanently in place especially while traveling. This mount slips over the black indoor antenna. There is a little notch in the back for the wire to pass through.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen