Slicer Discord
Wedge Battlebot V1  – 3D-Druckmodell von MakerWorld MakerWorld
Electronics

Wedge Battlebot V1

25 Downloads
14 Likes
12 Makes
Zum Modell
After many models I finally made one good enough so i'd share it!I used deer tech switches, N20 motors, flysky i6, cheap ESC's from amazon, and Generic Lipo Batteries from amazon. Screws and nuts were just laying around. You can set them to your size or measure and buy off a site like amazon. I uploaded a photo with all the elctroniocs so you can see where they go. You can sell, give or do anything with this for free :)Boost Me
Kategorie
Electronics
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen