Week Clock (with 3D printed face)

A clock to give you the vaguest idea of what the time is.This is an analogue clock that rotates once per week, with a single hand. Assembly instructions:Place nuts into hexagonal groves on ‘clock sides’ (a small amount of glue may be necessary however I did not need any)Insert clockface into ‘clock sides’ (hot glue around inside perimeter to keep it in place) - clock face may need to be printed in two parts and held together with the days insert. Securely glue ‘battery casing’ to gear platform. Insert purchased reverse clock mechanism into ‘battery casing’ (make sure it is battery side down so the battery lines up with the opening on the back of ‘battery casing’. I secured the nut and washer that came with the mechanism to the outside of ‘battery casing’ to keep the mechanism in place.Use ‘plug’ and ‘plug with short pin’ to secure ‘G2_20 tooth’Use ‘plug’ and ‘plug with long pin’ to secure ‘G3_10+20 tooth.Insert ‘70 tooth SECOND PIN’ through ‘G4_70 tooth’ and into ‘70 tooth PIN’ (fasten