WELS logo

This concept has been in my mind for months, without sketching anything I had the concept of what I wanted, I just needed a few hours to design it in tinkercad, it was tricky getting the tolerances correct. But I have to say it turned out really nice, and it should make a nice gift for any WELS enthusiast. If you don't know what the WELS is, it is short for Wisconsin Evangelical Lutheran Synod you can check it out at http://www.wels.net

Printing instructions: This is an easy print. The red piece is the only one which needs supports. Don't use platform adhesion for any of them it would effect the ability to insert one piece into another. I wanted to keep this small for anyone with a smaller print bed. It should work fine to scale it up, however this was not designed to be scaled down, and I would imagine that the tolerances would be really tight for most printers.

There are guidelines for the use of this logo please check out the PDF before using this for advertising or