Thingiverse
Jewelry
Ver Modelo
"whale" brooch
10
Descargas
8
Likes
0
Makes
I made a "whale" brooch
I have already made a lot of jewelry, but for this competition I wanted to make something new and different.
"whale" brooch the body part measures 5 cm, width of 3 cm is a depth of 2.23 mm
"whale" brooch the water part measures 7.9 cm by 2 cm and is 2.23 mm deep
19 min printing time for both parties
# ANYCUBIC3D
3D PRINTING SETTINGS
50% fill rate sufficient for jewelry
50% printing speed not too fast for better rendering
215 ° PLA printing temperature
60 ° plateau temperature
0.1 layer thickness
0.8 shell thickness
without support
I have already made a lot of jewelry, but for this competition I wanted to make something new and different.
"whale" brooch the body part measures 5 cm, width of 3 cm is a depth of 2.23 mm
"whale" brooch the water part measures 7.9 cm by 2 cm and is 2.23 mm deep
19 min printing time for both parties
# ANYCUBIC3D
3D PRINTING SETTINGS
50% fill rate sufficient for jewelry
50% printing speed not too fast for better rendering
215 ° PLA printing temperature
60 ° plateau temperature
0.1 layer thickness
0.8 shell thickness
without support
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
