Thingiverse
Wharfedale Logo
par karlv_3d
0
Téléchargements
0
Likes
0
Makes
If for some strange reason you need the Wharfedale logo, because your new 2nd hand speaker's one was missing (or any other reason), well here it is!
Printing and installing:
-I would recommend printing in 100% density for maximum strength
-Once finished, glue the two halves together
-I painted it with black spray paint, and then did the letters and border with white nail polish and a fine brush
-For installing, I put a bit of hot glue on the pins and pressed it in. That way I could remove it if necessary, because hot glue is weak
Be sure that the size fits your speaker/appliance.
Some dimensions:
-Mounting pin spacing: 36mm
-Pin diameter: 2mm
-Total height (excluding pins): 5mm
In case you didn't notice, this model isn't an exact replica of the original. I thought having a border looked better for a 3d printed model.
Printing and installing:
-I would recommend printing in 100% density for maximum strength
-Once finished, glue the two halves together
-I painted it with black spray paint, and then did the letters and border with white nail polish and a fine brush
-For installing, I put a bit of hot glue on the pins and pressed it in. That way I could remove it if necessary, because hot glue is weak
Be sure that the size fits your speaker/appliance.
Some dimensions:
-Mounting pin spacing: 36mm
-Pin diameter: 2mm
-Total height (excluding pins): 5mm
In case you didn't notice, this model isn't an exact replica of the original. I thought having a border looked better for a 3d printed model.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
