Wheel Bowl

After printing a Wheel Headphone Holder I thought the design could also work nicely as a bowl.So I printed one as well where the rim is visible at the bottom inside the bowl. The inner surface as well as the rim itself was printed in PLA Silk to create a shiny look. The bowl consists of three parts in total, which helps to reduce filament changes and therefore also waste. It also cuts down the print time significantly. If you prefer you can even skip the print of ring inside! It’s only there for the matching look. Additionally the speed of the first layer as well as the speed of all top surfaces is reduced to further improve print quality. On the underside there are five notches to glue in rubber feet with a diameter of 10 mm, preventing the bowl from slipping. The parts are simply plugged together and do not require any screws or glue. You can also find a smoke detector cover and a headphone holder in the same design on my profile.https://makerworld.com/en/models/1801592-wheel-cover-f