Thingiverse
wheelbarrow handle
door Kristopherson
2
Downloads
0
Likes
0
Makes
I'm adding a new simple project - maybe it will be useful to someone.
These are wheelbarrow handles, which are made of a pipe with an outer diameter of 32-32.5 mm.
I also used two inner lines, about 0.5 mm thick each, to stabilize and block the overlay when applied.
Below I present the parameters on which I printed but everyone can use different ones if they think it is right.
Layer
0.16
Infil
25%
Speed
60 / s
Material
PLA
CURA slicer reported bugs in the project, but don't worry if your slicer also reports it. Prints fine despite this.
These are wheelbarrow handles, which are made of a pipe with an outer diameter of 32-32.5 mm.
I also used two inner lines, about 0.5 mm thick each, to stabilize and block the overlay when applied.
Below I present the parameters on which I printed but everyone can use different ones if they think it is right.
Layer
0.16
Infil
25%
Speed
60 / s
Material
PLA
CURA slicer reported bugs in the project, but don't worry if your slicer also reports it. Prints fine despite this.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
