Thingiverse
Wheelie bar No Prep
von wingnut51
19
Downloads
11
Likes
0
Makes
Wheelie bar 30mm inside width
300mm from center of Kyosho rear axle to the center of rear wheels on bar when used with mount
used 5x10x4 bearings on rear
Fitted m3 x 12mm screws to assemble
Have 3 size bars for different pitch angles of chassis
300mm from center of Kyosho rear axle to the center of rear wheels on bar when used with mount
used 5x10x4 bearings on rear
Fitted m3 x 12mm screws to assemble
Have 3 size bars for different pitch angles of chassis
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
