MakerWorld
Vehicles
Model downloaden
Whimsical Airship
175
Downloads
228
Likes
101
Makes
This is a fun model to print that will be at home in any office or study. It is meant to hang by two points from the top, but I will probably make some sort of stand for it in the future. I didn’t get time to get quite everything I wanted in to this one so it might get a future update to motorize the propeller and a proper stand, and perhaps I will make a version that is more of a toy and less of a model – this version is fairly delicate and is more meant to be displayed than played with. Printing:There are a lot of small details in this model – I recommend 0.16 or 0.12 mm layer height, but if you have to 0.2mm will work.The only part that needs support is the middle section of the balloon. Support it from buildplate only around the perimeter and block the supports for the middle pegs. My print profile is set up to optimally orient everything and with the few color pieces already done. I used the Textured PEI prints for everything but the fins and blades, but whatever buildplate you ch
MottN publiceert ook op
75 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!