Thingiverse
whisk adapter drill shank (openscad)
door renschler
24
Downloads
28
Likes
0
Makes
Printed it sideways with supports so that it's not weak against stresses perpendicular to drill bit axis.
But that means it's more likely to break if the fit is tight with the whisk handle. Mine broke on insertion, so I just wrapped a strip of duct tape around and it worked fine.
But that means it's more likely to break if the fit is tight with the whisk handle. Mine broke on insertion, so I just wrapped a strip of duct tape around and it worked fine.
renschler publiceert ook op
11 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
