Slicer Discord
Whistle – 3D-Druckmodell von Thingiverse Thingiverse
Whistle – Bild 1 Whistle – Bild 2 Whistle – Bild 3 Whistle – Bild 4 Whistle – Bild 5

Whistle

von Zaggo
2.9k Downloads
2.7k Likes
271 Makes
Zum Modell
Better Living with MakerBot, Episode 2
You probably all know this situation:
You're supposed to ref a soccer game in less than 1/2 an hour and you cannot find your whistle. You're screwed!

But from now on you're out of trouble: Fire up your trusty MakerBot and print a new whistle in 26 minutes!

This object prints the pea right inside the whistle. Since the pea is connected to the rest of the object only at one tiny point, it's quite easy to break it loose after printing with a small screw driver or tweezers.

I probably pushing luck a little bit with bridging the top layer. So far I printed the whistle twice without problems.

As always, I added the object as .obj file (wavefront), which can be imported into AOI and Blender.

The gcode file is the one I used to print the whistle on the image. The gcode file contains an experimental raft with additional "blobs" on the second (interface) layer.
You might want to generate your own gcode file with skeinforge settings, teste
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
2 Farben
Einteilig 2 Farben / AMS Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Farben
2 (AMS/MMU empfohlen)
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen