White Board Stand

These four parts were designed and printed so that we could anchor an extra classroom whiteboard to our cabinets for teacher use. The two identical bottoms pieces have slits in them fit for the bottom of the white board and raise it up just enough so that it is flush with the top of the cabinet. This allowed us to anchor the top of the whiteboard to the top of the cabinet with our piece and screws.
The lofted hexagonal prisms had a base radius of 10 cm and had a total height of 11.75 cm. At the top of the loft was another hexagon with a radius of 3cm. Finally, to fit the whiteboard, there is a cut extrusion down 4.25 cm and 1.65 cm thick. We printed this part with our volcano nozzle for the most strength however, this may have affected the tightness of our cut. Our cut was z cm thick but it ended up being a bit of a loose fit. This turned our completely fine and works for our whiteboard but when printed on your own printers, you may have to change the thickness of the cut if it is to