White Rabbit

White Rabbit, a character from Lewis Carroll's Alice's Adventures in Wonderland. Alice first meets the White Rabbit at the very beginning of the story, while he is muttering "Oh dear! Oh dear! I shall be too late!" Alice then follows him down the rabbit hole into Wonderland. No supports are required. If you have the proper filament colors, no painting is needed. The assembled model is 250mm tall. The model is in proportion to my other Wonderland models. Enjoy, and don't get lost while going down the rabbit hole of 3D printing! Print instructions Rafts: Doesn't Matter Supports: No Resolution: .2mm Infill: 10% Notes:** Refer to the notes below for helpful printing and assembly instructions Building the Model Colors (there are no multiple printed pieces) Yellow: shirt collar .. Light blue: pants .. Red: jacket watch_hands (contains two parts) .. Green: umbrella_middle .. Brown: umbrella_top umprella_bottom .. Clear/Transparent: glasses_lens .. Purple: nose tie_left tie_right .. Pink: ear_pink_left ear_pink_right eye_pink_left eye_pink_right tongue .. Black: watch_pin eye_black_left eye_black_right eyebrow_left eyebrow_right numbers .. Gold (see the notes for a comment on the gold): glasses_rim watch_knob watch_middle watch_rim1 (rim1 and rim2 are the same) watch_rim2 .. White: tail hand_left hand_right foot_left foot_right head watch_face .. Any color (hidden pieces): body_pin knob_pin Printing and assembly tips Printing tips 1-No supports are required. 2-The tie_left and tie_right pieces should be printed with a brim. Oddly enough I also wound up using a brim for the shirt piece. Use your own judgement for some of the smaller pieces. 3-The parts should fit nicely when printed cleanly or with a slight first layer squish. A reminder, first layer cleanup also applies to the inside edges of parts. Holes for pins that are on the print surface should be clean of first layer squish. Parts such as the collar and shirt have edges that are on the inside of the model that also n