Thingiverse
Whoop Gate
von Klattrup
62
Downloads
58
Likes
0
Makes
So this is my take on an awesome little Whoop gate.
The gate consists of:
- 1m transparent plastic tube with a 12mm outer diameter and a 9mm inner diameter
- 1m LED chain with 10 LED's and a 2xAA battery case
- This base
Here in Denmark you can build 5 gates for approximately 150 DKK which translates to ~23 USD
ATTENTION! - I have just printed this once (the one in the pictures) and I had my temp set all wrong. I did have to fiddle a bit to clean it up, but with good printer settings you should have no trouble with it. :)
The gate consists of:
- 1m transparent plastic tube with a 12mm outer diameter and a 9mm inner diameter
- 1m LED chain with 10 LED's and a 2xAA battery case
- This base
Here in Denmark you can build 5 gates for approximately 150 DKK which translates to ~23 USD
ATTENTION! - I have just printed this once (the one in the pictures) and I had my temp set all wrong. I did have to fiddle a bit to clean it up, but with good printer settings you should have no trouble with it. :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
