Wicked Edge Sharpener Upgrade
por ThaFlash_LA
19
Descargas
12
Likes
0
Makes
I don't understand why my images are warped. My other projects show fine, and nothing has changed.
This is a series of upgrades for the Wicked Edge 1st generation sharpener.
This replaces the base with 2" x 1" 80/20 aluminum extrusions, changes the side rails to 1" 80/20 extrusions, and swaps the sloppy shaft and linkages for tight tolerance linear motion components.
You'll need a digital angle cube to set your angles because you won't have the reference points, or just sharpie the edge and adjust until you get to where you need to be.
I've added a BOM from McMaster-Carr but I used spare components from another project. Aside from the list below, you'll also need some spare 1/4"-20 nuts and washers, and possible extra 80/20 screws and nuts.
47065T147x1
91185A398x1
6111K448x6
47065T101x1
60645K221x2
6381K41 (cut down to about 3/8" length)x2
2424K11x2
47065T267x2
47065T257x2
47065T281x2
47065T107x2
47065T278x2
1031K63x2
This is a series of upgrades for the Wicked Edge 1st generation sharpener.
This replaces the base with 2" x 1" 80/20 aluminum extrusions, changes the side rails to 1" 80/20 extrusions, and swaps the sloppy shaft and linkages for tight tolerance linear motion components.
You'll need a digital angle cube to set your angles because you won't have the reference points, or just sharpie the edge and adjust until you get to where you need to be.
I've added a BOM from McMaster-Carr but I used spare components from another project. Aside from the list below, you'll also need some spare 1/4"-20 nuts and washers, and possible extra 80/20 screws and nuts.
47065T147x1
91185A398x1
6111K448x6
47065T101x1
60645K221x2
6381K41 (cut down to about 3/8" length)x2
2424K11x2
47065T267x2
47065T257x2
47065T281x2
47065T107x2
47065T278x2
1031K63x2
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!