Thingiverse
Widdle Wight Bar
von TheBigUglyOne
1
Downloads
0
Likes
0
Makes
Do you have a stock Jeep covered in ducks? then you need a Widdle Wight Bar to go on your pavement princess.
- I split the print into two because I am a simple man with a single filament printer but i wanted a multicolored print.
- The letters are press fit into the base ( i.e. just a bit of tappy tap tap with a small hammer...) probably want to add a dap of glue to the light inserts though.
The pockets are designed to take a 30mm x 10mm x 5mm magnet off of Amazonia
- Glue the magnet in the pocket, then glue the divider that came with the magnet to the magnet that way you will never have to worry about having a direct magnet to paint job interaction ( scratch )
- Also printing out of PETG would be a smarter choice because it will handle direct sunlight and summer temps better.
- I split the print into two because I am a simple man with a single filament printer but i wanted a multicolored print.
- The letters are press fit into the base ( i.e. just a bit of tappy tap tap with a small hammer...) probably want to add a dap of glue to the light inserts though.
The pockets are designed to take a 30mm x 10mm x 5mm magnet off of Amazonia
- Glue the magnet in the pocket, then glue the divider that came with the magnet to the magnet that way you will never have to worry about having a direct magnet to paint job interaction ( scratch )
- Also printing out of PETG would be a smarter choice because it will handle direct sunlight and summer temps better.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!