Thingiverse
Wig/Hat stand
von gambafrolla
60
Downloads
65
Likes
0
Makes
A 5 feet wig holder with minimal material, fastest and easiest printability (one shot print without support ) and robustness granted.
No supports are needed.
A large build plate is needed, around 250mm x 250mm.
The Z axis must be around 330mm.
Here you can find a video of the wig holder: https://youtu.be/VBlGI_7qpp4
All designs are designed to be printed in spiralized outer contour (vase mode) with 0.6mm or 0.8mm line width, both versions are available. This will guarantee no seam and fast and consistent print. You can use a 0.6/0.8mm diameter nozzle or just tweak the line width via SW using CURA. With a 0.4mm nozzle you can reach up to the double of line width, 0.8mm.
There are 2 designs of the wig holder:
- Type A: the simpler version.
- Type B: more elegant version with a bell shape on the bottom part
Share your result posting a MAKE, thank you.
Print it and share your results. It's easy! Click "post a make" or download [3D Geeks: for 3D Printing APP](ht
No supports are needed.
A large build plate is needed, around 250mm x 250mm.
The Z axis must be around 330mm.
Here you can find a video of the wig holder: https://youtu.be/VBlGI_7qpp4
All designs are designed to be printed in spiralized outer contour (vase mode) with 0.6mm or 0.8mm line width, both versions are available. This will guarantee no seam and fast and consistent print. You can use a 0.6/0.8mm diameter nozzle or just tweak the line width via SW using CURA. With a 0.4mm nozzle you can reach up to the double of line width, 0.8mm.
There are 2 designs of the wig holder:
- Type A: the simpler version.
- Type B: more elegant version with a bell shape on the bottom part
Share your result posting a MAKE, thank you.
Print it and share your results. It's easy! Click "post a make" or download [3D Geeks: for 3D Printing APP](ht
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
