Wiggle Snake

Wiggle Snake, As long as you put the pause in the Slicer, the printer should pause after doing two layers of the overhang and the hotend should (hopefully) move out of the way.Take your tulle and cut it to length. I didn't want it sticking out both ends, so I just made sure it went into the tail section and head section. I cut 4 pieces and stacked them together to try to get extra strength in the snake (I have only done these with 4 pieces of tulle so far and am unsure how strong a single piece will be).I like to tape my tulle down with blue painters tape (if you're going to use tape at all, use this type), but I know magnets are also commonly used for this.Once it is all set, resume your print and make sure it gets through that next layer without catching on the tulle. As long as it makes it through that next layer, the rest of the print should be fine because the parts shouldn't even dislodge at this point as the tulle will hold them all together!BE CAREFUL taking the sna