Thingiverse
Wiimote holder
von AshTeriyaki
17
Downloads
15
Likes
0
Makes
A holder for a single WiiMote (Without rubber sleeve). It has a gap in the back to allow the wrist strap through.
I printed this with 100% infill to give it a little more weight, but you could do less I suppose.
I printed this with 100% infill to give it a little more weight, but you could do less I suppose.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
