Thingiverse
Winch Cable Stopper
by matts2bad
57
Downloads
66
Likes
2
Makes
Couldn't find a winch cable stopper locally so I made one. Print with the most flexible filament you have and at a high infill (50% or higher) to avoid deformation. TPU is preferred and PETG is a close second.
Requires x4 M5 20mm cap screws and nuts. There is wiggle room for up to a 40mm cap screw but you can't go shorter than 20mm. Use loctite if you don't have M5 lock nuts.
Requires x4 M5 20mm cap screws and nuts. There is wiggle room for up to a 40mm cap screw but you can't go shorter than 20mm. Use loctite if you don't have M5 lock nuts.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
