Winchester .22LR Case Base

This object was made in Tinkercad. Edit it online https://www.tinkercad.com/things/4NLviz4bgcB

The base part of the case was breaking off at the part that holds the lid. Since the lid and perforated parts were still good, I made a replacement base that should hold up better than the original part. The original lid and perforated .22LR carrier parts are reused. When loaded, the lid fits tightly, preventing it from sliding off when carrying these in your range bag or pocket. It will slide on and off as needed. If you find it too tight, then just file down the supports on the inside a little.

I have revised it to make the fit better.