Slicer Discord
Wind Maker / Fan Amplifier – 3D-Druckmodell von MakerWorld MakerWorld
Other House Models

Wind Maker / Fan Amplifier

7 Downloads
6 Likes
1 Makes
Zum Modell
If you like this or it benefits you, consider leaving a tip. Sleeping in the fall after it's cooled off outside can be difficult at time for me. I get used to the sound of a fan all night in the summer and then when that is taken away in the fall I don't sleep well until I readjust. This amplifies the internal fan and it's natural wind noise to allow you to more comfortably adjust, or just to fill the silence with a bit of sound. based on the position you set the holes in the housing, the volume and pitch change allowing you to customize the experience to whatever suits your needs. For this project you'll need a 120mm variable speed (optional) computer fan, some kind of 12 volt power source for it, 5 M3x10 screws, and a 15x21mm on off switch (also optional). See the pictures for each stage of the design.These are the switches it was designed for: https://www.amazon.com/gp/product/B01N2U8PK0/ref=oh_aui_search_detailpage?ie=UTF8&psc=1 (If using WM Inside Top V2 you may ne
Kategorie
Other House Models
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Mindest-Druckbett
21 mm (Klein)
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

Nothing Spectacular veröffentlicht auch auf

30 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

2 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen